I just bought front and rear axles with 4.88's, and arb lockers already installed in them. I guess my question is what do i need as far as wiring to make these arb's work. I know i'll need a compressor. I was thinking of just going with the arb compressor that comes with the harness, but after that im lost. do I just need the arb solenoid, switch, and air lines to go along with this compressor. Any info would be helpful.

 

did some research, I just need everything that comes with an arb air locker except the air locker. does anyone know where to get this stuff.

 

http://www.arbusa.com/ Look under compressors

 

Northridge4x4

 

I have all the parts you need in stock give me a call if you have any questions

David

 

sent you a pm david but I'm going to give you a call tomorrow. thanks