I got my JK on a 4" lift and put on xenon flat fenders i want to bring my tire size up from a 34" but i have the corners of my body sticking out into my now larger wheel wells. Before I get retarded with my sawzal and grinder, can i remove the full corner without causing any damage to the structure or only a small bit?

 

The infamous "tire shredder", I just used a Dremel to grind off the corner and round it off.

 

mainly rear but if i fix the rear might as well do front too

 

Yeah, I am not just talking about the tacked pieces at the end im talkin the whole section of body sticking out into my wheel well. Today I talked to my buddy who is a welder and we are going to remove the whole section of the body sticking out and weld new plates into the sections I remove.

 

umm... you talkin' 'bout sheet metal removal along with modding the pinch seam? or just the pinch seam. if your talking about tubbing the wheel wells then be sure to post pics... please.