I just replaced my track bar with a teraflex HD track bar I went for a long ride and no problems. I just went to the store and my esp bas and traction control lights came on.... Any ideas why? My steering wheel is a Lil off now that the new bar is in. But I measured the length to a 16th of an inch to the old one.

 

That's where you start. 5 minutes and wrench, and go for another drive.

If you aren't sure how, there is a DIY alignment writeup up in the writeups area. (index stickied right at the top)

 

I just recentered the wheel and the lights are still on.... Their on constant. The systems are shut down its not engaging the traction control while driving..... I tried to pull the batter to turn lights off but nothing. Jeep drives straight as an arrow down the road tho now

 

Chances are you will need to go in for an alignment. I had the same thing happen when I installed my lift. I didn't get the new trac bar to the exact length and it shifted my axle off a bit.

 

I checked everything. It's as if their not even connected but all connections are secure

 

This Shit is so dumb how the hell is a solid steel bar turn electronics off..... Wtf

 

Lights on could be a faulty sensor

 

Just had the sensors replaced under warranty a few weeks ago...

When in doubt drive it out! I took her for another ride and not even 30 seconds into the ride the lights turned off!

 

My lights have been on for the past year. I have really given up and I get code c1210 I believe it is. Something about g sensor low circuit

 

Our's will come on when driving in a cross wind for too long or sometimes just at random. I ignore them, traction control has been disabled for a couple years now so they mean nothing to me lol.