Nicely done, great tackle on the single open with gate design

 

Almost done
Added transitions on the lower corners.




here is a closer view of the support pin


With carrier. total weight in this picture 109 lbs.

 

Made my third brake light bracket today.

 

it looks really sharp...personally....I'd probably just have done away with the third brake light, but it's really impressive

 

nice work realy, nice welds to. i think i will copy both your bumper is that fine with you

the rear one look realy unique. but i think mine will have both corner part joined at the middle. i will run spareless.

 

Thanks for looking everyone. Feel free to use any of my ideas on your projects.
Imitation is the highest form of flattery, or something like that

 

Those corner transitions look alot better

Nice work man

 

Really looks solid. What are you gunna do for a finish? (I have a feeling you already said this but I dont really wanna go back and look)

 

Just going to spray paint it black. Eventually I will make side steps/ rocker gaurds. I want to Powdercoat or Line-X everything at one time.

 

Finished for now. I have had some time to drive the Jeep a few times with the bumper, and no rattles
Tried to take some pictures, sun was reflecting on the paint a lot.
I have a lot of experience with the brand of paint I used. It will go from gloss to semi-gloss after a month or so of sun exposure. The plan is to Line-x or some brand of bed liner in the future. I am fairly happy with the results.