Is it o.k.

Reply Subscribe

Thread Tools

Feb 6, 2013 | 01:43 AM

GunDude

Thread Starter

JK Super Freak

Joined: Dec 2010

Posts: 1,060

Likes: 0

From: South Carolina

Is it o.k.

To put in rear upper adj. ca's and set pinion to 2 degrees under being inline with the stock ds until i put in the coast ds.

Feb 6, 2013 | 03:52 AM

hooper

JK Enthusiast

Joined: May 2012

Posts: 433

Likes: 0

From: Rosharon, Texas

I would measure the ones you take out and put the new ones in with the same measurement. You can adjust when you get the new DS later if needed.

Feb 6, 2013 | 04:01 AM

rickster

JK Enthusiast

Joined: Feb 2010

Posts: 347

Likes: 1

From: Puerto Rico

Did that untill I get a DS with the correct lengh. I have had no problems so far, even at full articulation in an RTI, with the rear sway bar discoed.

Feb 6, 2013 | 05:36 AM

GunDude

Thread Starter

JK Super Freak

Joined: Dec 2010

Posts: 1,060

Likes: 0

From: South Carolina

I have both front and rear coast ds sitting in shed. I need to get a torque wrench that will go 160 ft.lbs. but, want to put uca's in and adj. till i adj with stock shaft till i pick up wrench.

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last