For those of you running a 3″ lift or greater and are looking to improve the handling of your Jeep JK Wrangler, EVO Manufacturing has just released an outstading steering correction kit that you’ll definitely want to get. Below is the press release that they just put out:



EVO JK Draglink Flip Kit When lifting your JK 3” or greater, it is highly recommended to correct some of the steering geometry that has been altered with the lift. The EVO JK Draglink Flip Kit does just that and more!

· Raises trackbar mounting location 3” at the axle to help correct roll center and steering angles of a lifted JK.
· Roll center is greatly improved giving better handling of the vehicle on and off road
· Complete bolt-on design that gives greater strength to already prone to failure factory front trackbar bracket
· Comes complete with new forged draglink
· All bracketry made from 3/16” thick laser cut and CNC bent sheetmetal
· All bracketry is finished in a corrosion resistant Black Powdercoat

Note: Drilling of the passenger side steering knuckle with 7/8” drill bit is required to complete the install

EVO JK Draglink Flip Kit
$299.99
+ Shipping $19

For more information regarding this or any EVO Manufacturing product, please contact Andrew Perle, Product Engineer - EVO Manufacturing Inc. PH:714-870-5515 • FX:714-870-1130 • www.evomfg.com

Also, please let them know where you heard about this news!!

 

Thanks for the heads up WOL!!! This setup looks pretty nice and for $300 that's a steal.

 

it's a great deal and a mod that every jeep should have if lifted 4" or more. of course, this kit is made for a jeep that only has a 3" lift and you guys can certainly benefit from it as well

 

Nice job! I'm sure they're going to sell pretty well!

 

I need this!!! Thanks for posting it!

sent from DroiD.

 

Awesome! Price is perfect and quality and function have gotta be A+ coming from Evo. My next mod for sure.

 

Looks like a great product.

 

not bad. Looks the exact same as AEV's but $50 cheaper.

We could all use an extra $50, right?

 

Looks good another great product from ORE.

 

Does this re use the factory pitman arm joint?? I only see the knuckle end joint on draglink in the picture.

sent from DroiD.