I'm installing the teraflex leveling kit that only uses the spacers and longer sway bar links. Never really done this before and I'm not sure exactly how the new sway bar link should go on or where the washers go. Each link came with one washer. The picture on the directions doesn't show the entire sway bar link but it appears it goes up top. If anyone has the longer links, not disconnects, and can post a picture I would really appreciate it.

 

Yeah TeraFlex has always had bad instructions, although they keep saying they are updating them... I found it very useful to watch their YouTube videos and read different pdf's on their website to fully understand part installation. It gets difficult when they send new parts with directions still showing the outdated parts too. In the end it's all a learning experience.

 

PM teraflex, they'll get ya squared away

 

Yep x2 on that. also look at the stock links before you remove them it will help with the new ones.

 

I usually take some pics of the original stock installation with my phone so when my CRS kicks in (right about mid-install) I can go back and refresh my memory...