Rear Shock Mounts
Thread Starter
JK Freak
Joined: Jun 2008
Posts: 883
Likes: 0
From: Philly, PA
Rear Shock Mounts
Hi all...
So last week i installed the SkyJacker 2" budget boost and used the supplied bar pin studs to secure the rear upper shock mounts. the next day, the bushings were completely disintegrated. i went to Q-tec... a 30 min drive... and bought http://www.quadratec.com/products/16315_627.htm artie was nice enough to replace the bushings for me.
my question is this... do i need the metal "sleeves" that go thru the bushings, like in the lower busing?
help a noob out?
So last week i installed the SkyJacker 2" budget boost and used the supplied bar pin studs to secure the rear upper shock mounts. the next day, the bushings were completely disintegrated. i went to Q-tec... a 30 min drive... and bought http://www.quadratec.com/products/16315_627.htm artie was nice enough to replace the bushings for me.
my question is this... do i need the metal "sleeves" that go thru the bushings, like in the lower busing?
help a noob out?
Last edited by paramaniac; Jun 29, 2008 at 05:56 PM.
