Replacing rubi7 front locker.
Thread Starter
JK Newbie
Joined: Aug 2011
Posts: 14
Likes: 0
From: Levittown
Replacing rubi7 front locker.
so I am taking her to the jeep dealer to determine why my locker is not disengaging. If I was forced to replace the whole locker, what would be my best route.? 
and where is the puke emoticon? 
JK Jedi
Joined: Apr 2011
Posts: 4,482
Likes: 2
From: Neenah, Wisconsin
JK Jedi Master
Joined: Jan 2008
Posts: 11,463
Likes: 165
From: Austin <--> Colorado Springs
35 spline shafts are 1.5".
The tube outer diameter is 2.5", with 1/4" walls. If I did the math correct, that leaves a 2" inner diameter. You're saying that isn't enough room? Even though people are running those shafts in those housings?
The tube outer diameter is 2.5", with 1/4" walls. If I did the math correct, that leaves a 2" inner diameter. You're saying that isn't enough room? Even though people are running those shafts in those housings?
JK Jedi
Joined: Apr 2011
Posts: 4,482
Likes: 2
From: Neenah, Wisconsin
Lol its not the tube size thats the issue. You would have to replace all the outers with dana 60 parts to make it work. Its a pain and add up. Better off doing a dana 60 swap.
Lol wheres the link to people using them without doing as i stated.
Lol wheres the link to people using them without doing as i stated.
Trending Topics
JK Jedi Master
Joined: Jan 2008
Posts: 11,463
Likes: 165
From: Austin <--> Colorado Springs
In the other thread. Where is your link to people replacing with d60 parts?
