Anyone know the answer? Is it still x297/760 size or larger? Just saving up money for mods and would like to know. I want to eventually get alloy shafts and joints for 37s.

 

As far as I know they are still 760. Never heard or seen anything different.

 

Ahh boo I was hoping it was some new halfbreed size, lol. Guess I'll have to go CTMs with 36/37s

 

they are the crossbreed joints

1350 center and i believe a 297/780 ends

 

1350 (1330 with 1350 ends) is the driveshaft size, not axle joint....or are they now one in the same?

 

Do a search. There was a lot of speculation and information on this board regarding the new u-joint sizes back when they first came out. The last I heard they were larger than 760 in the 44, but I don't know what they are. I questioned the size in the 30, but still don't know that either.

 

I obviously have....and still no answers :toung:

searched "u-joint" "d44" dana 44" , etc with nothing

 

Maybe this will help.

https://www.jk-forum.com/forums/show...ght=axle+joint

 

Sorry, I guess since it was so OBVIOUS, I didn't even need to reply. Even still, here's a 2-page thread where it was discussed: https://www.jk-forum.com/forums/show...t=axle+u-joint

There are others as well, but you probably already knew that, right?:toung:

 

Thanks

ohh and obviously you knew I din't find that since d30 and d44 are too short and I didn't search ujoint, just u-joint, lol.