Hey, I've searched but haven't found these ones.

Have you guys seen these handles for the back?

http://www.quadratec.com/products/55012_910X_PG.htm

They look really clean but was wondering if anyone has had any experience with them

 

I have had mine for about a month...work well and are happy with them.
Got mine from Quadratec.
Cheers

 

I went grab handle crazy with Rugged Ridge, and I have the: front rollbars, windsheilds, rear sides, headrests, and soundbar handles. Not one has let me down. I like them.

However, if you can sew at all, or know someone who can, might want to reinforce the stitching where the most stressed is applied when pulling on them hard. My fire extinguisher holder broke when I tried to tighten the straps too tight.

 

check this out. get you some brass grommets and DIY. Ive loaded some biguns with no deaths or injury.

http://www.clcboats.com/shop/products/boatgear/0000-FGH00.html

 

Kind of like this write up!

http://project-jk.com/jeep-jk-write-ups/163


chuck

 

here, try this thread. These were the first thing I put on Jeep, about 6 months now, all is good

https://www.jk-forum.com/forums/show...ghlight=german

 

Yea ordered those for the JK back in early 07. Nice and easy mod for the cost.