Just replaced my clutch and throw out bearing and not even 20 miles in and its just as noisy as it was before. Beyond pissed off

 

Mine has sounded like a can of marbles for 40k miles

 

But 20 miles on this thing? Thats got to be a joke

 

Mine was replaced at 3k under warranty. So far so good.

 

I have 80k on the jeep. And i replaced the clutch with a spec stage 3 plus clutch/ throw out bearing it should be bulletproof in my eyes

 

Quite annoying indeed. Mine lasted roughly three months before it started clamoring again. I put in an ACT HD kit that came with a TOB, didn't find out until later that it was the same OEM TOB. Shortly after I picked up a national bearing one that everyone says is the ticket, just never got around to doing the swap... then I blew out my shoulder and wound up selling it to buy an auto.

 

I've been semi-budgeting for when mine finally goes. It drives fine, rattles some, but I've never felt it needed dealt with since jeep said they wouldn't warrant my clutch.... At about 20k I was told its a wear item and I could have abused it causing it to rattle.