I was currently looking to purchase an ORFab, or Poison Spyder bolt in cage. I am now leaning towards doing a weld in, custom cage. Does anyone sell just the sideplate that runs along the dash? I love the design of the Poison Spyder but would like to design my own weld in cage. I know BTF used to make them for TJ's but can't find any for JK's

 

If your capable and competent enough to design and build a full custom cage Im sure you can make the same plate. Or better yet do it right and take the A-pillar thru the dash

 

^ that side plate offers very little strength, best to go thru the dash. Rock hard may sell that as a windshield kit.

 

I was wondering about the strength. Seems the Poison spyder is the best design. THat being said, how difficult is it to run the tube through the dash. I don't mind cutting into things, I just don't want to start and find out it is an impossible task. I also daily drive the jeep 15-18K miles per year and don't want to modify the dash to the point it creaks.

 

IF strength is a concern then do it right. Going thru the dash isnt the end of the world just time consuming.

Here are 2 threads of cgaes i made for jks

https://www.jk-forum.com/forums/modi...d-cage-259341/

https://www.jk-forum.com/forums/jk-s...w-cage-259111/


But if you dont want to go thru the brain pain of making it work synergy has done all of the hard work for you


Synergy Suspension :: Jeep JK :: Synergy Suspension 07+ Jeep JK 2/4 Door DIY Sport Cage Kit

 

Check out the poly performance weld in kit, there are various configurations and parts.

 

If you email EVO they have their weld-in cage kit too. Its not on the website but if you jet them an email they should be able to guide you.