I have a rugged ridge modular front bumper with the pre runner gaurd on it. I also have the rrc side armor gaurds. I was trying to hold out for the RR rear bumper with tire carrier but I dont know if they will ever get that in production. What bumper do you guys with this set up run or thin would match well. I would like to keep my factory tow package if pos.

 

I was looking at the BOA rear tube bumper:

http://www.quadratec.com/products/12108_20X_PG.htm

It kind of follows the same theme as the front with the Pre-Runner guard on it. Any chance you could post some pics of your Jeep with the Side Armor Guards? Preferably a shot that shows the whole side of the Jeep including the front.

 

the purejeep rear bumper looks factory, is tough and will allow you to keep your factory hitch receiver. i am currently running the lod signature series rear bumper and it has a hitch receiver that is integrated into the bumper itself. here are some pics of what they look like....

purejeep




lod signature

 

The Shrockworks rear bumper/tire carrier looks good and uses the factory hitch.

 

The Bulldog Fab would look good.

 

Expedition One goes with everything!!!

 

Shrockworks! That is what I will be getting.

 

X2 on the LOD signature series. Really well made and no squeeks!!!

 

I will try and get a pic of it tomorrow. There are already some pics of it on my profile.

Is the expedition one origanal finish the one you have on yours. It looks close to my rr bumpers but the finish looks a lil to glossy to match.

 

Actually, that is a fresh coat of Herculiner (it dulls a little with time). You can get the Expedition One with black powder coat or bare and finish it however you need to.