I have installed my ARB Twin compressor under my passenger seat using the ARB supplied harnesses and have run the power to the battery but I still need to do the Ignition and Dash Illumination cables.

Does anyone have any suggestions for where I can splice these two wires in at on a 2012-2013 JKU?

This is all I have left to finish my install but wanted to make sure I tapped into the right lines.

TIA

 

What is the lumination wire going into the steering wheel?

 

I dont have a compressor but i have spliced into the cig lighter plug on the dash. its easy to get to and wired to the ignition so the switch wont stay luminated when the vehicle is not running.