moving on up !!
Thread Starter
JK Freak
Joined: Nov 2008
Posts: 613
Likes: 0
From: costa mesa ,ca
the coilover mounting kit is 609.00 out the door at outlaw they said i mite need to get wheel spacers but will see with my off set will take pictures tomorrow when i do the install and do a small write up i hope .
just joshing, congrats man it sounds like your rig is on it's moving on up to the east side with the jefferesons!
JK Freak
Joined: Nov 2008
Posts: 686
Likes: 2
From: San Diego, CA
i bought eddies 12 king coil over and the outlaw off road bolt on coil over set up for the front of my jeep, i have also got a jks front track bar and will also be getting installed my 5:13 gears and a je reel drive shaft . i will post picture on the install
this should be fun
this should be fun
. Good to see ya'll this weekend too, I'll be back down in socal in the fall and can't wait to wheel! Post pics when you get everything set up.
JK Enthusiast
Joined: Apr 2009
Posts: 143
Likes: 0
From: Oakland, CA
Russ I have yet to regear and have had my jeep longer then anyone on here, I still run 3.73 on 35s :P Dont feel bad
Ha ha ha, just messin'...it looks like I'm gonna be the last one in SoCal to re-gear! 
JK Jedi
Joined: Mar 2009
Posts: 8,931
Likes: 6
From: San Marcos, CA
Thread Starter
JK Freak
Joined: Nov 2008
Posts: 613
Likes: 0
From: costa mesa ,ca
ok the coil-overs in the front are done i have two problems 1st one the esp bas light is on and the 2nd problem is i am driving a bro jeep now i need to find some 4" rear springs maybe 6" lol drive nice i had to take the trany skid off it was rubbing the drive shaft i get the new shaft tomorrow that should fix that prob. but all in all it is not a bad kit there are a few things lower brackets do not work with evo c2 gussets had to modify them and then i welded them to the front housing i also welded supports for the track bar mount and upper control arm we put in a wood relocation bracket . the upper mount is hard to get a drill in there to drill the holes wish there was a templet so you can drill them from the bottom we scribed the top and then used a plasma cuter to make the hole then drilled up to make it the right size .
this is not a doit your self bolt in kit but it is a solid kit i will post pictures in a few
this is not a doit your self bolt in kit but it is a solid kit i will post pictures in a few
