So What Was Done to Your Jeep This Week?
Attachment 456160
A better pic of the 315/70/17 Duratracs installed. They ride so much better than the BF Goodrich stock Rubi tires. They measure exactly 34.6" @ 28psi. Calibrated the procal and all is well.
Front and rear G2 Chromoly Axle shafts, replaced drivers side exhaust manifold. Tomorrow in to ORW for a leaky pinion seal and a new Coast 1350 rear drive shaft. Then off to get a check up and alignment from Dr. Mike at Roger Daniel's Alignment and Brake.
Made an exhaust yesterday

Clearence looks much better than having that stock trash can muffler

I didn't buy a universal exhaust hanger so I made one out of some scrap and bolted it to where the factory bumper bolts up to.

It didn't take too long to do this but the hardest part was getting the right angles from two 90 degree pipes that I bought and had to cut down. I'm pretty happy with it, I still need to get a turn down tip and maybe paint it black. I can always remove it really easy to put the stock muffler back on(that's IF I get a exhaust fix it ticket) :-)
Best part of this project was I only spent about $50
Clearence looks much better than having that stock trash can muffler
I didn't buy a universal exhaust hanger so I made one out of some scrap and bolted it to where the factory bumper bolts up to.
It didn't take too long to do this but the hardest part was getting the right angles from two 90 degree pipes that I bought and had to cut down. I'm pretty happy with it, I still need to get a turn down tip and maybe paint it black. I can always remove it really easy to put the stock muffler back on(that's IF I get a exhaust fix it ticket) :-)
Best part of this project was I only spent about $50
Waiting at dealership for my free 5-year LPW inspection... fingers crossed.
Update: Everything passed! Only issue was water pump leaking a little, and its covered under warranty. Yeeeeeeah.
Update: Everything passed! Only issue was water pump leaking a little, and its covered under warranty. Yeeeeeeah.
Last edited by TURTLECON; May 11, 2013 at 09:28 AM.




