Notices
Stock JK Tech Bulletin board forum regarding issues with OE (original equipment) components of the Jeep JK Wrangler (Rubicon, Sahara, Unlimited and X) such as factory suspension parts, engine, transmission, body parts, interior fixtures and the on-board computer.

Cranckshaft Position Sensor

Thread Tools
 
Old 03-20-2013, 06:18 AM
  #1  
JK Newbie
Thread Starter
 
groundup's Avatar
 
Join Date: Mar 2013
Location: RI
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Default Cranckshaft Position Sensor

Hey guys I need a little help locating the cranck position sensor on a JK sahara. I think I found it already but I'm not 100% sure and would like any input from more experienced folks

This is a picture I snaped of what I think is the cranck sensor. This picture was taken looking from under the car on the passenger side where the bell housing mate to the engine block. Can someone please confirm is this is the sensor I am looking for?

http://www.flickr.com/photos/68139118@N05/8574021135/http://www.flickr.com/photos/68139118@N05/8574021135/ by http://www.flickr.com/people/68139118@N05/, on Flickr

And this is a close up

http://www.flickr.com/photos/68139118@N05/8575114558/http://www.flickr.com/photos/68139118@N05/8575114558/ by http://www.flickr.com/people/68139118@N05/, on Flickr
Old 03-20-2013, 08:53 AM
  #2  
Sponsoring Vendor
 
Morris4x4Center's Avatar
 
Join Date: Jun 2011
Location: Pompano Beach, Florida
Posts: 1,546
Received 1 Like on 1 Post
Default

Originally Posted by groundup
Hey guys I need a little help locating the cranck position sensor on a JK sahara. I think I found it already but I'm not 100% sure and would like any input from more experienced folks

This is a picture I snaped of what I think is the cranck sensor. This picture was taken looking from under the car on the passenger side where the bell housing mate to the engine block. Can someone please confirm is this is the sensor I am looking for?


jk cranck sensor by yo mama, on Flickr

And this is a close up


jk cranck sensor1 by yo mama, on Flickr

Yup Looks about right!
Old 03-20-2013, 02:28 PM
  #3  
JK Newbie
Thread Starter
 
groundup's Avatar
 
Join Date: Mar 2013
Location: RI
Posts: 2
Likes: 0
Received 0 Likes on 0 Posts
Default

Thank you so much for your reply man, simple post but helped me A LOT

Replaced the sensor and its all back to normal and it only took me 10 minutes, what a great day! time for a and here is one for you bro enjoy



Quick Reply: Cranckshaft Position Sensor



All times are GMT -8. The time now is 05:40 PM.