Notices
Stock JK Tech Bulletin board forum regarding issues with OE (original equipment) components of the Jeep JK Wrangler (Rubicon, Sahara, Unlimited and X) such as factory suspension parts, engine, transmission, body parts, interior fixtures and the on-board computer.

rubicon sticker

Thread Tools
 
Old Dec 6, 2011 | 04:46 PM
  #1  
Tonka_yellow's Avatar
Thread Starter
JK Super Freak
 
Joined: Nov 2011
Posts: 1,602
Likes: 6
From: morgantown wv
Default rubicon sticker

I need help from a rubicon member. If you would be so kind to measure your hood sticker and tell me from the center of the sticker to the hood latch and the center to the bottom of the hood. I found some numbers but they are measuring from the bottom and side of the sticker. Since I am NOT putting a rubicon sticker on my hood I would like to know the center measurements. Thanks in advance
Reply
Old Dec 6, 2011 | 05:22 PM
  #2  
Lumberjack500's Avatar
JK Newbie
 
Joined: Jul 2010
Posts: 26
Likes: 0
From: Beaumont
Default

You want from the i to the latch? I understand the center of the letter to bottom of hood.
Reply
Old Dec 6, 2011 | 05:38 PM
  #3  
itsarubiconday's Avatar
JK Enthusiast
 
Joined: Jan 2009
Posts: 230
Likes: 0
From: Greenville, MI
Default

Hey Bud,

I get 15.75" from the middle of my "I" the left edge of the hood latch. (on the passenger side). The height of the lettering 1 1/16", and it's 5/8" to the bottom of the letters. Do the math can I am having a serious brain fart. 11/16" to the center?

Anyway, hope this helps.
Reply
Old Dec 6, 2011 | 05:50 PM
  #4  
Tonka_yellow's Avatar
Thread Starter
JK Super Freak
 
Joined: Nov 2011
Posts: 1,602
Likes: 6
From: morgantown wv
Default

Originally Posted by itsarubiconday
Hey Bud,

I get 15.75" from the middle of my "I" the left edge of the hood latch. (on the passenger side). The height of the lettering 1 1/16", and it's 5/8" to the bottom of the letters. Do the math can I am having a serious brain fart. 11/16" to the center?

Anyway, hope this helps.
Thank you my sticker is like 24" x 3" so I might just wing one side and measure to do the other
Reply
Old Dec 6, 2011 | 06:06 PM
  #5  
robsjeep9's Avatar
JK Junkie
JK-Forum Ambassador
 
Joined: Nov 2010
Posts: 3,802
Likes: 3
From: Kitchener
Default

Originally Posted by Tonka_yellow

Thank you my sticker is like 24" x 3" so I might just wing one side and measure to do the other
Just grab some masking tape to temporarily place it where you think it looks good.... adjust it until you find the perfect spot ..... Or did I just state the obvious????? Lol
Reply
Old Dec 6, 2011 | 06:09 PM
  #6  
Tonka_yellow's Avatar
Thread Starter
JK Super Freak
 
Joined: Nov 2011
Posts: 1,602
Likes: 6
From: morgantown wv
Default

I have done some stickers before. I just would like it to be some what close to a rubicon sticker
Reply




All times are GMT -8. The time now is 07:53 AM.