Trans case vent
Thread Starter
JK Newbie
Joined: Jul 2007
Posts: 71
Likes: 0
From: NE. Ohio
Trans case vent
I know where the axle vents terminate but cannot find where the trans case vent tube is routed. Does it come up into the engine bay, or does it end above the transmission housing?
JK Freak
Joined: May 2008
Posts: 601
Likes: 0
From: Brownsboro TX
https://www.jk-forum.com/forums/show...ight=breathers
One edit on all that I wrote on that thread though, the transmission and t-case do NOT share a breather, the breather for the tranmission is up front close to the bell housing and terminates behind the motor on the firewall, have not relocated it yet.
The stock tranfer case termination point is about 1 foot higher than the top of the bell housing on the firewall behind the motor.
Let me know if you have any questions, but that thread should help you out!
I love it when people think about attention to detail like this, it is such an easy thing to do that can save you a whole lot of money in the long run and it is easy and cheap to do.
One edit on all that I wrote on that thread though, the transmission and t-case do NOT share a breather, the breather for the tranmission is up front close to the bell housing and terminates behind the motor on the firewall, have not relocated it yet.
The stock tranfer case termination point is about 1 foot higher than the top of the bell housing on the firewall behind the motor.
Let me know if you have any questions, but that thread should help you out!
I love it when people think about attention to detail like this, it is such an easy thing to do that can save you a whole lot of money in the long run and it is easy and cheap to do.