If I go with a
#1
JK Newbie
Thread Starter
Join Date: Oct 2012
Location: Texas
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
If I go with a
4 inch rc suspension lift and either 37 or 38 inch tires, will I have to trim or replace my fenders or can I leave them as they are? Your feedback is mucho appreciato'd
Last edited by Bryanc182; 11-01-2012 at 07:44 PM.
#3
JK Freak
Join Date: Mar 2011
Location: Vancouver, BC
Posts: 791
Likes: 0
Received 0 Likes
on
0 Posts
Unless you run a truck load of bump stops, I'm pretty sure you'll have to trim (if going off road). Running 2.5" RC lift and 35's, and I had to trim. 1.5" taller lift and 2"-3" taller tires... you get the point. Also, it a lot depends on the width of the tire and backspace. Wider tires and less backspace contribute to rubbing on the fenders under flex. I got 12.5" wide tires and 4.5" backspace.
#4
JK Newbie
Join Date: Apr 2012
Location: Baltimore, md
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
I just bought rc3.5" flex and planning on going with 37s and flat fenders. My friend has 2.5" with 35s and just cut a little bit of the pinch seam. Am i going to have to cut anything else?
#5
JK Jedi
i only have 35s , but did not have to cut anything if i wen to 37s i would have to cut alot...
#6
JK Super Freak
Join Date: Nov 2011
Location: Riverside, CA
Posts: 1,031
Likes: 0
Received 0 Likes
on
0 Posts
Do you have the factory bumper? Might hit it if you do.
I have 35's and a 2.5" RK lift and was hitting the front bumper + air dam and fenders. Just chopped the bumper and removed the air dam this weekend. Fenders are next.
Also will probably need to trim the pinch seam if that hasn't already been done.
I have 35's and a 2.5" RK lift and was hitting the front bumper + air dam and fenders. Just chopped the bumper and removed the air dam this weekend. Fenders are next.
Also will probably need to trim the pinch seam if that hasn't already been done.
Trending Topics
#10
JK Super Freak
Join Date: Nov 2011
Location: Riverside, CA
Posts: 1,031
Likes: 0
Received 0 Likes
on
0 Posts