What was done to your JK this week?
JK Enthusiast
Joined: May 2012
Posts: 202
Likes: 0
From: grande prairie alberta
Replaced stock breather front and rear left factory trans alone just fine I bought 14' of 5/16 fuel line hose and couple hose clamps came to total of $27 .
Took front breather hose and is tied to other wire loom I got for my duallys I got it zip tied in 4 spots along the way I left a lot of slack for my 2.5" rk max travel im saving for atm and will trim if needed.
The rear I took off my back tire and drilled into the plastic cover under light area new to 2012 I think before was open before.
Used a 3/4 bit to drill out hole perfect size for the 5/16 hose since was almost 3/4" diamater. Then used breathable foam spray not expanding the foam filled the factory foam wich I had drilled threw perfectly.I also drilled two small holes behind hinge bracket about 1" apart then used zip tie to secure breather hose.oh forgot sprayed holes drilled with rustolium spray bomb so rust wouldnt start on new expossed metal.
I used all factory hose brackets also just bent front bracket that had the factory zip tie so would not rub hose...
Oh for the breather cap to install in new hose I just heated hose up with a lighter for a few secs and cap just slid in and when cooled air tight..
Took front breather hose and is tied to other wire loom I got for my duallys I got it zip tied in 4 spots along the way I left a lot of slack for my 2.5" rk max travel im saving for atm and will trim if needed.
The rear I took off my back tire and drilled into the plastic cover under light area new to 2012 I think before was open before.
Used a 3/4 bit to drill out hole perfect size for the 5/16 hose since was almost 3/4" diamater. Then used breathable foam spray not expanding the foam filled the factory foam wich I had drilled threw perfectly.I also drilled two small holes behind hinge bracket about 1" apart then used zip tie to secure breather hose.oh forgot sprayed holes drilled with rustolium spray bomb so rust wouldnt start on new expossed metal.
I used all factory hose brackets also just bent front bracket that had the factory zip tie so would not rub hose...
Oh for the breather cap to install in new hose I just heated hose up with a lighter for a few secs and cap just slid in and when cooled air tight..
JK Enthusiast
Joined: Apr 2012
Posts: 353
Likes: 0
From: Orange County
JK Newbie
Joined: Dec 2012
Posts: 59
Likes: 0
From: Abilene, TX
Nice. What lights/kit did you use?
Replaced OEM backup lights with LED lights, what a difference!!!!! Show here next to a buddies with the stock lights
Attachment 422847
Attachment 422847
JK Newbie
Joined: Feb 2013
Posts: 82
Likes: 0
From: Blue Ridge Alberta
First of all I'm new to the site and would like to say this is the best site I've found for info and mods for me to do to my 2012 rubi, thank you
Hester day I installed my 5" Piaa lights on the windshield and also while I was doing the wiring for the piaa's I decided to do the front signal/ marker mod I read about on here and it worked AWSOME!
Hester day I installed my 5" Piaa lights on the windshield and also while I was doing the wiring for the piaa's I decided to do the front signal/ marker mod I read about on here and it worked AWSOME!