Did the spacer fail? What brand is that?

 

Just finished bedlining my fender flares:

 

I added a locking fuel cap!!!

 

They look pretty close, but I haven't seen an X/Rubi flare up close in a little bit. I am not a professional painter, so I wasn't able to get a completely smooth finish all over. The Duplicolor bedliner is good, but the spray cans sputtered on me a bit. I found that having some Q-Tips on hand to remove the excess from the spatters helps...wish I would have found that out before I was halfway through.

I think the texture looks really good matched with the texture of the black hardtop.

 

I installed my daystar switch panel.

 

Installed:


Rusty's Pre runner with Pure Jeep D-Ring Shackle Mount
Attachment 14318

Attachment 14319

 

Fender chop - MallCrawler Edition!

(thank you mikey1989 for the measurements & pics, and thank you serveapurpose for talking me through some of the finer points).

Just some quick pics for now











Then I wanted to see if I could get the underside of my jeep as clean as Rubimon's . It was covered with grease from my blown rear driveshaft, what a mess.

My husband poked his head out of the house thought this was the funniest thing he ever saw and decided to take a picture so you guys could have a good laugh, too -





Yes, I did come out of there absolutely covered in grease head to toe.

 

I like...

 

I need to lift my jeep a few more inches. There was not enough room for me to roll under mine, so I had to slide on my back.

 

...changed the fog light bulbs..some old lady backed into my tail gate..but it hurt her more than me