That is one tough-lookin' Jeep! Very cool!

 

In the last couple weeks I've installed my ARB bumpers, diff covers and IPF 900 lights. Here's a pic finally.



Kinda dirty tho...

 

 

Mel and his boys did it.

 

Sure, here's an idea what it looks like.










The stubby light coming out of the cigarette lighter plug is one of those cheapo Bell two position lights on the long flexible shaft, I just shortened the shaft a bit and re-soldered the connections. It's cheap ($3) and works great, plus it turns off when you switch off the Jeep.

I tried the Hurst grips out a little bit ago, yes, I should have let the JB Weld set up overnight, but it's been 5 or 6 hours and they are solid as a rock.

 

Took off the Mirror relocation brackets and put the mirrors back on the doors... I can actually see now. Also installed electrical wiring tubing on all the lights and cb wiring under the hood for greater protection and a cleaner look.

 

Finally finished the trim job on my front fenders, and installed some 50watt Ultra-effin-bright (the ones from JC Whitney) reverse lights.

 

Rough Country 4" lift
https://www.jk-forum.com/forums/show...8&postcount=11

 

I was going to say that the kit needed some parts but after looking at your sig you built it right!!! Great Job. Isnt the satisfaction of installing all those parts just overwhelming? AWESOME JOB.

 

Well, I put on the evolution offroad coil overs on Sunday, you can check out the write-up
https://www.jk-forum.com/forums/jk-show-tell-33/evo-coil-over-do-yourself-64197/