The posts keep it at the top, if we made it an official sticky, people would immediately cease reading it and start a new thread about it.

 

stock with no lift, for the monment it's ok, i don't wheeling hard in winter

maybe a BB lift in spring

 

I got my pre-runner light bar through Quadratec... It was at my door 2 days later

 

Almost had a heart attack when I looked at Steve&2jc's link to his River Raider's crusher corner install. I don't have the stones to cut up my Jeep like that. However, those are the baddest looking corners I have ever seen! Here is the link from his post if you didn't get to see it.
http://s119.photobucket.com/albums/o137/0074doorrubi/

 

Installed my Woods Hardtop saver Plates.

Placed a Quadratec order for Locking nuts, Mopar door sills, and a hood lock then got the conformation email that said everything was on backorder except for the nuts , dang do they actually keep anything in stock.

 

I'm sure it's because of the recessed ORO lite-dots. They look really good, but I don't think I could do it. The AEV's and all the other corner guards are made for using your stock taillights.

 

Ordered a Midland CB, 3" firefly, and the firestick 18' coax. Everything should be here on the 22nd. I can't wait, I haven't had a project to work on since I added my windshield lights 3 weeks ago.

I'm going to fab up an antenna bracket this week at work to mount the antenna on my 3rd break light.

JD

 

Lets see i got ARB lockers front and rear 5:13s full traction upper controll arms front and rear solid diff covers woods ss relocation kit evo front control arm skids jks rear track bar brace evo front axle gussets

 

I added my Ripp Mods ..... Supercharger !!!

 

Install Riddler Diff covers front and rear.