What was done to your JK this week?
JK Junkie
Joined: Jun 2012
Posts: 2,215
Likes: 2
From: rosamond, ca
Did driver side and painted em....will do all reinforcing tomorrow and possibly side plates to protect the area in front of door...
Now this is what I wanted for the front to be doved in and minimal width for canyons and notches...I rip the front fenders off on a regular basis....
Now this is what I wanted for the front to be doved in and minimal width for canyons and notches...I rip the front fenders off on a regular basis....
JK Newbie
Joined: Aug 2013
Posts: 9
Likes: 0
Man, I will be honest it sucked. You couldn't pay me to do it again, BUT.... Since its simplistic as a Jeep should be everything came apart with relative ease and went back together the same. It was just the sanding and prep work of removing everything that was the worst.... Prep work vs actually lining it was 10:1. I highly recommend. Takes about 3 days to cure enough to put seats back in without probs fyi.
JK Jedi
Joined: Apr 2011
Posts: 4,482
Likes: 2
From: Neenah, Wisconsin
Fixed My Shock Bolt
Put on the metalcloak rear track bar bracket and laughed....
Its obsurdly tall and my axle will be 2" off center until I get my damn rod ends in to finish my track bar...I wish that bracket wasnt so tall. I may have to cut it down and grind the sides for clearance.
Put on the metalcloak rear track bar bracket and laughed....
Its obsurdly tall and my axle will be 2" off center until I get my damn rod ends in to finish my track bar...I wish that bracket wasnt so tall. I may have to cut it down and grind the sides for clearance.
JK Junkie
Joined: Oct 2007
Posts: 2,565
Likes: 0
From: HAWAII
