My finger healed enough over the week that I could replace the crap bolts Rusty's gives you with their winch plate with real grade 8 hardware and placed the skid back on.



Sent from my XT1080 using Tapatalk

 

Here's the bastard that gave me 8 stitches in my finger.



Sent from my XT1080 using Tapatalk

 

Did the grill mod today








Sent from my iPhone using JK-Forum

 

Wife has Smittybilt XRC heavy duty rear bumper with swing out tire carrier. I had same one on my 08 JK before I traded it in in my Rubi.
Love it!! Will need to put a little grease on it for
Winter, so it don't squeak, but over all, Solid bumper!!! Just a few small, minor rust spots had to touch up after Winter, but no biggie.

 

Installed MORE engine/trans, front, muffler, evap skids and now Jeep a back at dealer getting leather and heated seats installed. It's getting close to being where I want it for now.

 

Got my Hi Lift Jack installed on the hood!

 

I'm a newb, so just getting started... Put on some KC's, bumper mounted with Quadratec mounts. Also added aluminum hood catches to replace stock rubber catches, and got the hoist installed in the garage looking forward to warmer weather in the coming weeks.

 

Well, still w/o my jeep. Has been at the stealorship for 2 weeks now. Should have it back this week.
Was burning 2 and half quarts every 700 miles...
They have replaced all the pinions and crankshaft bearings...manifolds.. etc.
thank god for powertrain warranty

 

Correct. I run ace rock rails on my 2 do or with the factory rail. I cut down my factory rail just because I run 37's and deleted the pinch welds on the rear fenders. No modification is needed if you dont run a larger tire than 35.

 

Added top and rear bumper right before the freeze!