Gave her some tattoos!

 

Installed some Katskinz I purchased from a forum member.

 

Where and how do you have it mounted?
How is it powered?
Did you add the camera?

 

Bought a needle for the grease gun and injected grease into the bootie on the intermediate shaft.

 

Installed spidertrax spaces.

 

Sorry the picture quality doesn't show the mount. There's a mount for the dash and it fits in the top tray area. The wire is plugged into the OBD port and routed up to the gauge. The power comes from the OBD wire once you turn the key. I didn't hook up the reverse camera but there is a hook up for one.

 

Got my Rugged Ridge engine/trans skid, muffler skid, and Hi Lift roll bar mount brackets today from the brown truck!

I've already got the Rugged Ridge front and rear lower control arm skids and the EGR skid.

I can't wait to get them installed! Thanks 4WD.com!

 

Swapped out the amber turn signals for clear ones. I like the look a lot better and it was an easy mod for $38.

 

Finally managed to get my CB finished up and installed in my dash.

 

I got a set of Strike Force Zebra half doors from Craigslist.



Sent from my d2lte using Tapatalk