Don't need to worry about tcase reprogramming with an '08.

 

Fitted a Savvy half door. Too bad its 25° out :(

 

sure ill snap one for you... it was fairly simple. chopped off stem and kept stock carrier, chopped low and painted... mounted to TF. reused the stock wires in their originial location and soldered to some 3m led strips i grabbed from amazon. wrapped the strips around the carrier close to where the wheel mounts - that was it. Lastly, i did put a masking tape strip around the outside of the led since the strip doesnt make solid contact to the carrier everywhere since its not perfectly round. pretty much followed this process from stangmike1 - whole project cost me 10 bucks, lol

https://www.jk-forum.com/forums/jk-w...ed-mod-308783/

only difference is his mount was perfectly circle due to his tire carrier. I have also seen where people use a dust cover and mount the led to that.

 

Ace Engineering rock rails installed. There the cleanest part of the Jeep, for now. I was going to wait on these but the wife wanted a step. Even stock height she has issues.

 

Cut my fenders Saturday. Finally enough snow melted off that I could take a picture.

 

So how long did it take you to do this?

northridge 4x4

 

thanks. Do you know if I need to get one for an 08 or can I go with a newer one?

 

cool thanks. Would love to see some pics.

 

Like 3 or 4 hrs. Used only a dremel. Didn't have anything else.

 

You can use any JK tcase from '07-'11 from either an auto or manual. You can also run '12+ case if it came from a manual.