I just recentley had the Evo sleeves and gussetts along with there control arm skids installed. When I got the jeep back I get a little "more" wobble when I am around 45mph and again around 60 to 65mph? Before I had this done I would get a little wobble around 45mph. I knew my aligment was off just a bit and was going to have one done anyway after the install. It seems to be worse now. I am wondering if I just need to check into more than the aligment. Could something else have happened to cause this?

I have adj uppers on the front running 35's

 

If the shop pulled the ball joints and arms I would be sure its all back together properly and torqued.

 

I dont think they did, but I am not sure.

 

If they didnt pull the ball joints and didnt take care not to over heat the area you could have heat damage

 

sounds like you have a problem but can't see how the c's and sleeves could be the cause.