Notices
Modified JK Tech Tech related bulletin board forum regarding subjects such as suspension, tires & wheels, steering, bumpers, skid plates, drive train, cages, on-board air and other useful modifications that will help improve the performance and protection of your Jeep JK Wrangler (Rubicon, Sahara, Unlimited and X) on the trail.

PLEASE DO NOT START SHOW & TELL TYPE THREADS IN THIS FORUM

Axle Guide Rings

Thread Tools
 
Old Oct 10, 2012 | 04:08 PM
  #1  
softpickle's Avatar
Thread Starter
JK Newbie
 
Joined: Mar 2012
Posts: 4
Likes: 0
From: VA
Default Axle Guide Rings

Hello. I am getting ready to install a set of nitro axle sleeves. I was reading the directions that came with them and they mention that my dana 30 front axle may have axle guide rings. Does anyone know if it does? My jeep is an 07 jk 2 door.
Reply
Old Oct 10, 2012 | 04:11 PM
  #2  
weebus's Avatar
JK Enthusiast
 
Joined: Apr 2011
Posts: 213
Likes: 0
From: salisbury nc
Default rings

not sure about 07 but my 11 had them
Reply
Old Oct 10, 2012 | 04:11 PM
  #3  
BoneShkr's Avatar
JK Enthusiast
 
Joined: Feb 2012
Posts: 483
Likes: 0
From: West Haverstraw, New York
Default

I don't know, but give this question a bit of time and I'm sure you'll have folks
falling over themselves to help you out with this issue.
Reply
Old Oct 10, 2012 | 04:13 PM
  #4  
chris@offroadevolution's Avatar
Sponsoring Vendor
 
Joined: May 2012
Posts: 1,423
Likes: 0
From: FULLERTON,CA
Default

Originally Posted by softpickle
Hello. I am getting ready to install a set of nitro axle sleeves. I was reading the directions that came with them and they mention that my dana 30 front axle may have axle guide rings. Does anyone know if it does? My jeep is an 07 jk 2 door.
its a plastic ring on the axle shaft. You'll know when you pull it apart
Reply
Old Oct 10, 2012 | 04:24 PM
  #5  
softpickle's Avatar
Thread Starter
JK Newbie
 
Joined: Mar 2012
Posts: 4
Likes: 0
From: VA
Default

Originally Posted by chris@offroadevolution
its a plastic ring on the axle shaft. You'll know when you pull it apart
ok. just wanting to make sure it wasn't something that i would have to tear into the axle to get prior to installation. thank you all very much for your help.
Reply




All times are GMT -8. The time now is 12:59 PM.