Originally Posted by _J__C_

.prothane.com/whatsnew.php

If you look at the picture on this page, the two spacers in the front(middle) go up front. The two on the outside go in the rear. The rubber "spacer/isolator" or whatever it's called that is above the factory springs goes under the spacer, and against the spring.

Originally Posted by medic_23387

Are they upper? It does not look like the old ones could insert into those.

Originally Posted by ALs07

I have the same kit. Check out the Black Diamond lift instructions, it's what I used. Use some grease on the new bump stops. You do not reuse the original ones.