Just wanted to post some pics of what i've done with her so far. I'm happy with the exhaust, no fumes inside but i do need some sort of heat protection on the floor above the muffler. The bumper is done for now, when i add a winch i'll be adding either a stinger or just a smaller hoop over the winch for protection. I was goin to fit the factory foglights in the bumper but i think it'll be too crowded with a fairlead in there. So some aftermarket lights are in the future...













So next I'm planning to make a skid to cover both the muffler and evap along with a oil pan skid as i've already had to hammer it out once.

 

Oh, and the pics are clickable...had some guys post on my local board that the pics were too small...lol

 

is that the stock mufler or new one?

 

Use your stock muffler heat sheild and move it, to the new location

 

Yep, I did the same and it works good

It looks hot here, but its just the reflection off my garage floor lol

 

Yep its a flowmaster super 40 series, very nice sound. And thanks, i think i'll do that with the old shield. how did u mount it? new holes in the floor?

 

I used three self tapping screws with washers, screwed into the frame cross members, and re-used one of the bolts holding the evap box, that you can see in the picture.

 

yea i'll take a small video of the jeep running this weekend and post it.