Daystar switch panel and 6-speed
JK Enthusiast
Joined: Jan 2007
Posts: 169
Likes: 0
From: Lake Arrowhead, Ca
HOLY SWITCHES BATMAN!!!!!
I have the Daystar panel and have never really had a problem. I did the push boot down mod and it works fine. Never had an issue with the 4X4 lever either.... Dont really need to "WRAP" my hand around it to push it forward. I just..... Ummmm.... push it.... Pulling into 4WD isn't difficult either. 2 fingers on top and pull. Works just fine. I like it. Its clean and factory looking and since its down low its out of side for the most part.
I have the Daystar panel and have never really had a problem. I did the push boot down mod and it works fine. Never had an issue with the 4X4 lever either.... Dont really need to "WRAP" my hand around it to push it forward. I just..... Ummmm.... push it.... Pulling into 4WD isn't difficult either. 2 fingers on top and pull. Works just fine. I like it. Its clean and factory looking and since its down low its out of side for the most part.
Last edited by wayoflifette; May 24, 2011 at 04:11 PM. Reason: removed blacklisted quote
JK Newbie
Joined: Jan 2012
Posts: 30
Likes: 0
From: Colorado Springs, Colorado
Ok this is what I did cause I had a problem too with the boot interfering. Push the boot slightly down and then place a zip tie right above tightly down to prevent from sliding back up.
JK Newbie
Joined: Dec 2011
Posts: 62
Likes: 0
From: Columbia, MD
Was going to mention the the rugged ridge!
JK Enthusiast
Joined: Jul 2010
Posts: 150
Likes: 0
From: Billings, Mt
Thanks!
