Driveshaft bend do to skid plate
Thread Starter
JK Enthusiast
Joined: Aug 2007
Posts: 165
Likes: 0
From: SAN JUAN P.R
HERE ARE THE PIC.
Right now have more material removed.Before it bend the driveshaft it have a 1/4 part of the trans. skidplate removed. I dont have images of the bended drive shaft.Later in the install I am going to post some pics of the skid and driveshaft at full flex to show the clearance
.
Right now have more material removed.Before it bend the driveshaft it have a 1/4 part of the trans. skidplate removed. I dont have images of the bended drive shaft.Later in the install I am going to post some pics of the skid and driveshaft at full flex to show the clearance
JK Enthusiast
Joined: Feb 2007
Posts: 183
Likes: 1
From: Albuquerque
Thanks for the pics. Did you bend the shaft on that little bar of skid you left between the hole you cut and the u-shape cut?
I removed my stock skid today, and will leave it off until I get an after market driveshaft. I thank you for the warning!
Your pics are pretty good, but when you do your write up a pic zoomed out would put it in perspective, maybe with something like a ruler near the cut would help us out.
Thanks
I removed my stock skid today, and will leave it off until I get an after market driveshaft. I thank you for the warning!
Your pics are pretty good, but when you do your write up a pic zoomed out would put it in perspective, maybe with something like a ruler near the cut would help us out.
Thanks