Has anybody put an E-Disco from an Rubicon on a non-rubicon? I was thinking about putting one from a 07 Rubi in my 07 X. It looks pretty straightforward if I look at the instructions for installing a new one from Mopar. Looks like all I would need is the wiring harness (wonder how much that goes for) and a switch ($40 from Quadratec). Am I missing anything?

 

i'm sure youd need a flash of some sort to get it working correctly.

 

That is correct. I did see that in the instructions.

 

do you have someone selling you one already? and if so how much are you buying it for? just out of curiousity.

 

Did that on my 08X, bought a Rubi chassis harness and switch pod from quadratech. After I installed the harness and the smartbar I took it to the dealer and had them flash the computer to turn in that feature. Works great! I think the harness was #52446.111 and was $75

 

I installed one on my X. Came out of a Rubi. Seller cut the harness out of Rubi and included it.

Dealer enabled it for me and I got the buttons from Quadratec.

 

Thanks for the great info, especially the part #'s.

 

i have one on the way. Any words of wisdom for the install?
thanks again.

 

If you are doing it in the garage with no lift, I highly suggest you stretch! You can get to everything but you have to be very bendy, lol. I laid the harness out on the ground first before I started feeding it through, kinda helped. When you take off your original, pay close attention to how it runs along the frame, itll save you a little aggrevation. There are a few hidden push pin retainers toward the rear, just break them it's easier that way.

 

Make sure you install it flipped! Don't want that pesky motor breaking on a rock or something