I swore up and down that I wouldn't go wheeling without installing my rear bump stops. Of course... I did. And now I have a bent rear bump stop pad. So how the heck am I gonna address this? Darnit!!!

 

Vicegrips with a 6ft pole attached to it over the handles.....







.

 

Weld a flat piece of steel over top of it and go from there. Back in business. Must've been one hell of a hit

 

yeah I gave it the business on a set of whoops testing out my new MC lift!!!!

Welded steel over the top was my first thought, but just wanted to check. Thank ya fellas!!!

 

The giant crescent wrench from harbor freight will fix that and adjust jam nuts too.

 

Oh a new tool? I'll try that first!!! Yay!!!! Although my wife is prolly gonna call u and be asking questions!!!

 

Well it's $27.99 so most likely you have enough in your stash you can use. At least I hope so, I'm in enough trouble with my wife I don't need any more angry wives coming after me lol

But seriously, if you have any jam nuts you need this wrench anyway

 

Pry bar

 

Just weld on a small cut piece of rectanglular steel tube the height of the bumpstop extension you need. I dont understand why people pay any more than $5 for rear bumps.