and cant figure out what the tapered pin is about...im sure yall know. thanks. old stabilizer died and there is a piece to move it higher, then obvious parts, then a tapered pin that doesnt want to fit in anything. thanks in advance for educated an ignoramus.

 

I dont think that tapered screw if designed for the 12-13 tie rod clamp.

 

Iv'e been asking for some pics on another thread. Please post some pics of the install when your done..

subscribed

 

I plan on using the OME, just wondered how the relocation bracket worked out.

 

That would make sense and explain my mystery. I've emailed ARB. When I hear back ill complete and post pics.

 

Go over to there aev website. Look under install directions for lift kit it will show you what parts you use to mount the ome. Also shows to mount it 16.5" center eye to center eye

 

I got these from a fellow forum Member. I converted them to JPG.

 

To bad they dont put this online so you can look it up.

 

Sure it's not for a Tj application?. My TF shock has a part similar for a TJ.

 

That part # is for JK. The components look like their TJ stuff though.