So What Was Done to Your Jeep This Week?
JK Enthusiast
Joined: Oct 2012
Posts: 162
Likes: 0
From: kentucky
What ^^ H8MUD said... the kit comes with a bracket and lugnut "studs" (use in place of top two lug nuts) to mount the factory 3rd brake light (you cut it off from the stock plastic neck). I was going to use delta lugnut hole LEDs, but they don't fit with this carrier. If I relocate my license plate to the spare, I'll probably use the ORO Lite mount, since it include the license illuminate light & red brake lights. I had it on my 08. Mine didn't come with a license relocate mount btw. Must be a separate thing?
JK Enthusiast
Joined: Nov 2010
Posts: 165
Likes: 0
From: San Diego, CA
Racelines, Fox 2.0's, and 4 inch teraflex springs. Thanks to Brut4ce for working in to the late hours to help get it all done! Thanks travis!
Attachment 517000
Attachment 517000
JK Enthusiast
Joined: Sep 2013
Posts: 191
Likes: 0
From: Brick, NJ
Wish mine would of came with a mount like yours. I'm not planning on relocating my license plate and don't like how it looks. Probably will call TeraFlex tomorrow to see if they have a different adapter like yours.
Former Member
Joined: Aug 2012
Posts: 1,748
Likes: 1
From: Oceanside - san diego, Ca.
Bypassed locked switches, mounted max ax, made spring retainers, lifted it 1.5" front 1" rear, did led lights on interior, synergy ball joints, , made fenders for the front....
Buddy got me a max ax so I mounted it on the roll bar and made some bars and riveted ot to the inside wall behind seats.....
Used a bolt with rubber bushing and a lug nut with the small center sleeve to center axe and push down keeping it centre and not wallowing out square hole or rattling....
Lower is bracket with pin going through handle at end with lock on it.
_---------------------------------------------------------------------
Buddy got me a max ax so I mounted it on the roll bar and made some bars and riveted ot to the inside wall behind seats.....
Used a bolt with rubber bushing and a lug nut with the small center sleeve to center axe and push down keeping it centre and not wallowing out square hole or rattling....
Lower is bracket with pin going through handle at end with lock on it.
_---------------------------------------------------------------------
Last edited by BRUT4CE; Dec 16, 2013 at 07:27 PM.
