Huntsville Alabama / Tennessee Valley Chat
JK Super Freak
Joined: May 2008
Posts: 1,916
Likes: 0
From: Madison, AL
...might be some good picture oportunitys. 
JK Junkie
Joined: May 2008
Posts: 3,386
Likes: 0
From: North Alabama
More wheeling w/ pics to prove it!!
Found a cave.
Inside - didn't figure out that limestone on the ground was falling from the ceiling until after I was home editing pics.
Pretty day, and the moon was even out.
Rock outcroppings along the top.
Aqua color swim hole.
Yet another creek crossing.
Inside - didn't figure out that limestone on the ground was falling from the ceiling until after I was home editing pics.
Pretty day, and the moon was even out.
Rock outcroppings along the top.
Aqua color swim hole.
Yet another creek crossing.
Last edited by JK-Rubi; Mar 8, 2009 at 12:08 PM.
JK Enthusiast
Joined: Oct 2008
Posts: 168
Likes: 0
From: Madison, AL
Just installed the Rugged Ridge front skid plate. The instructions says that it will protect Rubicon sway bar disconnect motor, but since I don't have a Rubicon I can't say for sure that the underbelly of the skid plate covers the disco motor. The front skid plate uses 2 mounting brackets attached to the sway bar mounts and nuts and bolts to the front under cross member of the Jeep. The finish of the skid plate is the same as the Mopar rock rails (OEM Rubicon). IMO the skid plate is solidly built (very heavy for being so compact). Just what I was looking for...I didn't want a skid plate that "stood out" from the rest of the Jeep. Trying to keep it clean and simple.
Before Pic of underside
Before Pic of sway bar mount location (note skid plate on the floor..all brakets were welded and gusset'd)
After Pic of sway bar mount location
After pic of skid plate installed
After pic of front of Jeep
Before Pic of underside
Before Pic of sway bar mount location (note skid plate on the floor..all brakets were welded and gusset'd)
After Pic of sway bar mount location
After pic of skid plate installed
After pic of front of Jeep
Last edited by NOBLING; Mar 8, 2009 at 09:04 PM.
Thread Starter
JK Freak
Joined: Jun 2008
Posts: 659
Likes: 0
From: Huntsvile, AL
hey guys,
A friend of mine is selling a 85' CJ wrangler that has rebuilt 4.6 liter, 2" lift, and 31" AT's for $3500. The rear end is the only thing needing replaced. Let me know if anyone is interested.
A friend of mine is selling a 85' CJ wrangler that has rebuilt 4.6 liter, 2" lift, and 31" AT's for $3500. The rear end is the only thing needing replaced. Let me know if anyone is interested.
JK Super Freak
Joined: May 2008
Posts: 1,916
Likes: 0
From: Madison, AL
Bear Hollow
Travis & I went to Bear Hollow management area on Sunday. This is the same place a few of us went to months ago and spent all day trying to find it out east of Huntsville.
All of the pix we took can be viewed at my rides na dfriends link below.
All of the pix we took can be viewed at my rides na dfriends link below.
JK Super Freak
Joined: May 2008
Posts: 1,916
Likes: 0
From: Madison, AL
yes I forgot. But I will say I absolutely love the ARB snatch strap. Have used it a couple of times and it works so mych better than a typical recovery strap. The elasticity in it really works to your advantage in pulling you out of a jam.
