Notices
Stock JK Tech Bulletin board forum regarding issues with OE (original equipment) components of the Jeep JK Wrangler (Rubicon, Sahara, Unlimited and X) such as factory suspension parts, engine, transmission, body parts, interior fixtures and the on-board computer.

Electronic Throttle Control Issues_Please Help.

Thread Tools
 
Old Nov 10, 2007 | 06:33 PM
  #1  
CRUISER1027's Avatar
Thread Starter
JK Enthusiast
 
Joined: May 2007
Posts: 144
Likes: 0
From: YUKON, OK
Unhappy Electronic Throttle Control Issues_Please Help.

So, Engine was running fine. I took it in this morning to get the G40 recall flashed (something/brake control) and drove all day without issue until tonight. Out of nowhere, I couldn't get past idle and the ETC idiot light came on. I assume this is some kind of safe mode. I can't find anything obvious to cause the problem. I tryed resetting the computer and resetting the code. When I stomp the gas pedal with the key on, the light goes off. But when I start it, it runs smooth for a few seconds and then the light returns and the sputter/miss in the engine does too. Any thoughts? All are greatly appreciated.
Reply
Old Nov 12, 2007 | 08:39 AM
  #2  
jcollett's Avatar
JK Newbie
 
Joined: Jul 2007
Posts: 39
Likes: 0
From: The Bluegrass State
Default

read my post above... this may be the beginning for you.... this is how my started.

the throttle light and G40 recall service prolly are not related.
Reply




All times are GMT -8. The time now is 03:29 PM.