Front drive shaft won't disengage.
#1
JK Junkie
Thread Starter
Front drive shaft won't disengage.
I hit some trails today had to put it in 4L after the trail ride. The front shaft won't disengage. It's still spinning but the dash says It's out of 4wd. Anyone have any ideas how to get it out? Or am I just crazy? The front DS is not supposed to spin when your in 2H?
#2
JK Jedi Master
The front drive shaft and the contents of the front axle will spin any time the JK is moving; even in 2wd.
That's because the wheels are still connected to the axle shafts.
That's because the wheels are still connected to the axle shafts.
#4
JK Junkie
Thread Starter
I took it out of 4L and put it in 2H for the last 1/2 mile the easy part and my buddy told me when I was slipping he said my front right was spinning. But I told him I was n 2H. That's why I'm asking.
#5
JK Jedi Master
Did you ever get it into 2wd? If not, is the lever floppy as if disconnected?
Last edited by ronjenx; 03-29-2013 at 05:08 PM.
#7
JK Junkie
Thread Starter
I think you were right. I must have had it in 4H... Weird part was the 4WD light on the dash was not lit.