JK-Forum.com - The top destination for Jeep JK and JL Wrangler news, rumors, and discussion

Notices
Stock JK Tech Bulletin board forum regarding issues with OE (original equipment) components of the Jeep JK Wrangler (Rubicon, Sahara, Unlimited and X) such as factory suspension parts, engine, transmission, body parts, interior fixtures and the on-board computer.

I Purchased a 3 piece hardtop for my 07 JK X, I have a problem

Thread Tools
 
Old 08-07-2019, 01:58 PM
  #21  
JK Enthusiast

Thread Starter
 
Dinky Dau's Avatar
 
Join Date: Jun 2019
Location: Ellijay, georgia
Posts: 159
Received 31 Likes on 27 Posts
Default
Originally Posted by LC Boyer
I think you could use a pop rivet, if you have some that will fit. Not much pressure on it
Thanks, I thought of that if the Rivnuts don't install properly..I will go be Lowes tomorrow and pick up some 6 mm nuts, washers and 1 long 6mm bolt.
Dinky Dau is offline  
Reply Like
Old 08-15-2019, 09:36 AM
  #22  
JK Enthusiast

Thread Starter
 
Dinky Dau's Avatar
 
Join Date: Jun 2019
Location: Ellijay, georgia
Posts: 159
Received 31 Likes on 27 Posts
Default

Finally finished, Footman Loop has now been relocated with new trim..Glad this is finally checked off the list! Now off for new longblock install with new Alternator and starter as well with the new drivers seat track installed for 2inch further rear position...No more hitting the window handle with my knee...All finished then, will be all restored then!

After pic's
Dinky Dau is offline  
Reply Like
The following users liked this post:
LC Boyer (08-15-2019)
Old 08-15-2019, 10:40 AM
  #23  
JK Enthusiast

 
LC Boyer's Avatar
 
Join Date: Jul 2019
Location: LOS FRESNOS, TEXAS
Posts: 299
Received 69 Likes on 61 Posts
Default
Good news! Sounds like you have plenty to stay busy and out of trouble
LC Boyer is offline  
Reply Like
The following users liked this post:
Dinky Dau (08-15-2019)
Back to Subforum
Stock JK Tech
View Next Unread
Jku gas cap




Advanced Search
Quick Reply: I Purchased a 3 piece hardtop for my 07 JK X, I have a problem


Reply Closed Thread Share

All times are GMT -8. The time now is 06:59 PM.