Washing off the mold release. It's a big mold (for comparison, I'm 6'6") .



Then I decided that rather than scrub the mold release off with a Scotchbrite pad like I normally do, I'd let the water do the work so I turned the mold into a kiddie pool to let it soak a few minutes...

 

Dog Sledge ! Dual purpose Top ! It's gonna hurt when you cut up the wooden master.

 

I promise I won't post any photos when I cut up the master .

 

Oh, please do! Kill it in front of the world, it's good for us!

 

I've enjoyed reading this thread. What a talent! Great products. You should try out for "Shark Tank"

 

Thank you very much for the kind words, but Nooooo Thanks on Shark Tank or any other way of starting a business - I have no interest in being in business to sell anything, I do these designs and projects as a hobby and doing it as a business would take all the fun out of it .

 

I've been working with an RV window company to get sliders manufactured for JK half door uppers. I met with them yesterday and came away with this complete set of preproduction 4 JKU half door sliders, ready to install. I'll get them installed in some half door uppers later this week. More photos to come after I get them installed.

 

I'm at work and literally just let, "Hoooooly shit" come out a little too loud. Just to verify, do these replace the entire cloth portion or just the window itself?

 

Stay tuned, I'll post photos as soon as I get them installed.

 

I'm molding the first JK Safari Cab roof panel today. This photo was taken right after I shot white gelcoat in the mold. After lunch the gelcoat will be cured to the point where I can do the fiberglass layup.