What was done to your JK this week?
JK Enthusiast
Joined: Oct 2010
Posts: 154
Likes: 0
From: Anaheim, CA
Originally Posted by 10frank9
Used some of this and some elbow grease to return my fenders to their former glory:
<img src="https://www.jk-forum.com/forums/attachment.php?attachmentid=371792"/>
Here you can see the left side halfway done, big difference.
<img src="https://www.jk-forum.com/forums/attachment.php?attachmentid=371796"/>
Looking sharp now!
<img src="https://www.jk-forum.com/forums/attachment.php?attachmentid=371797"/>
Also picked up this tow hitch receiver from fellow forum member jeepin_tiger. Thanks!!!
<img src="https://www.jk-forum.com/forums/attachment.php?attachmentid=371800"/>
<img src="https://www.jk-forum.com/forums/attachment.php?attachmentid=371792"/>
Here you can see the left side halfway done, big difference.
<img src="https://www.jk-forum.com/forums/attachment.php?attachmentid=371796"/>
Looking sharp now!
<img src="https://www.jk-forum.com/forums/attachment.php?attachmentid=371797"/>
Also picked up this tow hitch receiver from fellow forum member jeepin_tiger. Thanks!!!
<img src="https://www.jk-forum.com/forums/attachment.php?attachmentid=371800"/>
JK Newbie
Joined: Apr 2008
Posts: 51
Likes: 0
From: charleston SC ( currently deployed to Kuwait)
that is pretty cool...i will be doing this before summer....
I got the idea off of another forum...
Here are the parts needed:
BMX foot peg
One 3/8 x 4 eye bolt (if I remember correctly)
Two 3/8 fender washers (I cranked these until they were dimpled to keep the eye bolt somewhat centered)
Three "normal" 3/8 washers (one inside the peg, two above and below the hinge)
One 3/8 x 1 1/2 bolt (holding eye bolt to peg)
Two 3/8 nuts (one inside peg, one on eye bolt)
Hopefully this helps. Attached is a close up.
Here are the parts needed:
BMX foot peg
One 3/8 x 4 eye bolt (if I remember correctly)
Two 3/8 fender washers (I cranked these until they were dimpled to keep the eye bolt somewhat centered)
Three "normal" 3/8 washers (one inside the peg, two above and below the hinge)
One 3/8 x 1 1/2 bolt (holding eye bolt to peg)
Two 3/8 nuts (one inside peg, one on eye bolt)
Hopefully this helps. Attached is a close up.
JK Newbie
Joined: May 2012
Posts: 12
Likes: 0
From: Clawson, MI
Finally put on my 3" BDS lift, Fox shocks, Rockhard engine skid plate, bumper and winch. Just need to put on the synthetic line and 35"s on Monday...can't wait for the new sneakers! Jeep camp in a week!!!!