This week I put a garvin inside water jug mount in with a rotopax 2gal tank. Took out my grille guard due to rust and added a genesis dual battery set up with optimas. Plus put on my stock wheels for winter. And put stock the muffler and intermediate pipe back on.

 

Yes. I still need to do some cosmetic stuff but got then back on. Going to spray sone undercoating in the rear wheel wells and get my winch back on today. I did the blinker mod for the side marker light. Really like that

 

Added an auxiliary backup light.

 

Install wasn't too bad. There is some minor cutting (notching out the top of the fender), but they give you a cut out template and the gasket will cover up any minor cutting mistakes. I did have some issues lining the snorkel body up with the cowl bracket they provide. But I was able to put enough pressure on it to get it lined up and bolted on. Took about 7 hours by myself (4-5 hours if I eliminated beer breaks). 😃

 

Wired to a switch or to the reverse lights?

 

Wired to a switch.

 

Opened up the dash to install my Lockpick so I can have a backup camera as well as unlock the navigation system. I hate not being able to enter an address while driving 99% of the time that's when I need it. I know there is the voice activation but I works like crap.

 

Thanks. I agree it is the nicest looking snorkel out there right now.

 

Goofing around with the grill mod. Not sure about the middle one. I was trying to figure a way to put stars in the middle one, but may end up just taking it out?
Go old Red, White, Blue!

 

it sounds like my install went the same way. Small amount of cutting. You do have to pull the fender off and it's a pain to get lined up properly again but it is well worth it.