can you get 35 spline chromo shadts for the rubi axles? next tire is going to be 38's, I dont wheel very often and this should be plenty for what I do.

 

i don't know about the rubi axle but if you run an arb in a sahara 44, you can. this is what i am running now.

 

I have been thinking about doing this when I lock my rear 44. Essentially, you just got the gears, lockers, and axle shafts for a Rubi D44? Did you have to replace the carriers or anything else? I figure if I'm going to be replacing most of this stuff anyway, I just as well do it right.

 

I read somewhere that Superior had not released their 35spline axles yet and although some shops were taking orders, no one was shipping.
Didn't confirm for myself, but maybe I should have.
I've been waiting to order!!

 

THIS MODIFICATION IS NOT POSIBLE FOR THE RUBICONS D44 AXEL,YOU CAN DO IT WITH A X or SAHARA D44 AXEL HOUSING

 

i have the first prototype. actually, it's off road evolution's old sahara d44 that was modded but now it's on my jeep.

yup. so far as i know, this can only be done on a non-rubicon d44 rear end.

 

What are the differents in the two housing that makes Saharas D44 able and not the other?

 

The internal clearance of the pumpkin in the rubicons d44 do not permitted the installation.
Remember the rubi d 44 have a sensor and actuator for the elocker
according to arb & ore is not possible

 

I imagine when/if the Rubi lockers start failing, they will be available for the Rubi with and ARB replacement locker.

 

If you were to remove the locker/sensor/actuator would you not have the same thing as an X/Sierra?