Hello everybody, so I have a 2012 JKU with a 6.4 hemi installed by BOR. my 2 main issues are the sudden engine die out after hitting the dunes or coming down it just suddenly switches off and the 2nd issue is the heating. It overheats fast which kills the fun, so I would like some technical assistance if possible from you guys. Contacted BOR but it takes ages to hear from them.

 

Call Burnsville offload I would bet the owner takes your call personally and walks you through the problems. Located in Burnsville Mn.PK

 

Try aev your engine swap most likely used their kit

 

Well my experience with them wasn't much fun.... Also the time difference is an issue, as I'm located outside the US . The build was done during my stay in the US.

 

Is your thermostat sticking?

Is the radiator clean?

Do you have the proper amount of antifreeze in the cooling system?

 

I hate to say it but typical for a hemi install....that's why many are pulling them and putting in a Chevy.

 

So where can I get more information on the Chevy and how do they adapt to the JK as in electronics......The Hemi just sucks

 

haha wow must be nice!! In that case screw hemi and LS and just get a 6BT Cummins!!! As others have said tho, I'd contact AEV or Burnsville for support

http://www.youtube.com/watch?v=brlm2qP5b0w

 

As long as it's got fenders...

 

haha i hate fenders! I'd take no fenders over $1000 set anyday