Dumb question, but what is the correct way to use the factory jack?

Reply Subscribe

Thread Tools

Apr 27, 2011 | 07:50 AM

#11

Mark Doiron

JK Jedi Master

Joined: Mar 2007

Posts: 14,800

Likes: 374

From: Midwest City, OK

Quote:

Originally Posted by Shankspony

... A floor jack is impracticable and usually not tall enough. Any suggestions?

...

One of these will fit under the rear seat of a four door, and still permit folding down the 60% side while leaving the 40% side up. It's what I carry. And a couple 4x6s to reach a little higher. You can also use a tie down strap to secure the axle so it doesn't droop if you decide to jack by the frame.

http://www.craftsman.com/shc/s/p_10155_12602_00950523000P?vName=Power+Tools+%26+E quipment&cName=Equipment&sName=Mechanics+Equipment &keyword=floor+jack&prdNo=1&blockNo=1&blockType =L1

Apr 27, 2011 | 01:36 PM

#12

JK-UTE

JK Freak

Joined: Apr 2009

Posts: 623

Likes: 0

From: Salt Lake City, Utah

Quote:

Originally Posted by RedJK2

Personally, I think the stock jack is better than no jack. And it's normally only used for emergency purposes.

Touche.... I agree 100%

Apr 27, 2011 | 01:41 PM

#13

pettym

JK Enthusiast

Joined: Jan 2010

Posts: 242

Likes: 0

From: Sterling, VA

if you can find a place to stick it, these things are awesome

amazon.com/Powerbuilt-640912-3-Ton-Bottle-Stand/dp/B003ULZGFU

May 6, 2011 | 08:59 PM

#14

jcrcan25

JK Enthusiast

Joined: Jan 2011

Posts: 240

Likes: 0

From: Greeneville, tn

jack

Quote:

Originally Posted by Biginboca

I have been using the factory jack under the axles on the axle tube itself in no particular spot, or sometimes under the pumpkin(s). But I noticed the jack has a cut out in the center as though it would fit over or into something so I wondered if I was doing it right?

pick it up with 2 hands and throw it away..... and buy a highlift...... if you have any lift or larger tires....the factory is totally useless