What was done to your JK this week?
JK Freak
Joined: Jul 2008
Posts: 782
Likes: 0
From: Southern MD
True, they just start another thread concerning the same thing (somtimes with the same title just a few threads down). I cant tell you how many threads I have read asking about "what is needed for a four inch lift" and yesterday I saw 10 threads about KC lights and wiring 
JK Enthusiast
Joined: Dec 2007
Posts: 494
Likes: 0
From: Rogers, AR
JK Junkie
Joined: Apr 2008
Posts: 2,265
Likes: 0
From: Albuquerque, NM
Ill get some pics hopefully tomorrow. The only issue was where the bracket comes to the right upper control arm mount. The gap was too big to weld almost to the point where we were going to weld a 3/16 plate on the inside to close that gap. But once we kinda tacked it in it sucked in from the heat and was good enough to get a bite. And the SS mount is questionable...
Last edited by Gokracer1; Dec 29, 2008 at 12:17 PM.
JK Enthusiast
Joined: Apr 2008
Posts: 133
Likes: 0
From: Mansfield, PA
Rough Country dual steering stabilizer Riddler diff covers and gear oil change. O and I got to play around in the snow 
check the videoo,
I really couldnt get that loose. The tires just dug down through the snow to pavement. http://www.youtube.com/watch?v=_JggXam61Z4
check the videoo,I really couldnt get that loose. The tires just dug down through the snow to pavement. http://www.youtube.com/watch?v=_JggXam61Z4
Last edited by wayoflife; Jul 24, 2009 at 04:42 PM.
JK Enthusiast
Joined: Dec 2007
Posts: 494
Likes: 0
From: Rogers, AR
Ill get some pics hopefully tomorrow. The only issue was where the bracket comes to the right upper control arm mount. The gap was too big to weld almost to the point where we were going to weld a 3/16 plate on the inside to close that gap. But once we kinda tacked it in it sucked in from the heat and was good enough to get a bite. Other than that it was good.
JK Enthusiast
Joined: Jun 2008
Posts: 199
Likes: 1
From: Cleveland, TN
Pics of the completed install...
This is the cover plate I had the guys at the machine shop fab for me. It is a temporary solution until I get my winch. I'm going to remove it over the holidays and put bed liner on it too...
